Table of Contents
Advertisement
4.4.3
Speaker
Refer to
Figure 4-13
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove the fixation screws [1] that secure the rear cover.
Refer to
Figure 4-13
4.4.4
Small Signal Board (SSB)
Refer to
Figure 4-14
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB[1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] .
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-14
for details.
for details.
2
Figure 4-13 Speaker removal
Mechanical Instructions
2. Release the connectors [2] and [3] that connect speake
with the SSB. Refer to
3. Gently lift the Speaker from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
3
1
1
3
3
back to
div. table
TPN16.3E LA
4.
Figure 4-13
for details.
1
2
Figure 4-14 SSB removal
EN 17
Q4 × 12
1
20100_103.eps
3
3
20100_104.eps
2016-Oct-28
Hide quick links:
Advertisement
Table of Contents
