4. On the computer display, click on the Connect button at the lower-left on the screen and
verify the red plot line is slowly moving across the bottom of the grid display.
5. Adjust the voltage scale to 1.88 volts.
Note: Please read through this procedure first before performing the experiment, as the
process go fast and requires prior knowledge of what is about to happen.
Procedure:
1. Attach the black lead of the 10 ohm resistor to the black OUTPUT terminal and verify a
similar plot as shown below. Notice that the resistance reading is at 10 ohms on the
meter below.
Figure 3.2 – 10 ohm Resistor Discharge Curve
34