Transport, Installation, Mounting; Transport To Installation Location; Installation; Mounting - Alpha-InnoTec WWS 121 Operating Manual

Transport, Installation,

Mounting

Observe the following when performing all work:
CAUTION
The tank must be installed in a frostproof
room, to prevent frost damage to the storage
tank, pipe system and connections.
NOTE
Install the storage tank as close as possible to
the heat generator, to keep the heat losses as
low as possible. Ensure the shortest possible
pipe lengths to the load.
CAUTION
The floor or ground at the place of installation
must be dry, firm and able to safely support the
weight of the tank.
 For the weight of the tank: dimensioned drawing
for the respective model.

Transport to installation location

To avoid damage during transport, transport the
storage tank (secured on the wooden pallet) to its final
installation location using a lifting truck.
WARNING!
The unit can tip over when being removed
from the wooden
transport with a hand truck or lift truck.
This can result in personal injuries and
damage.
► Take suitable precautions to prevent the tip-
ping hazard.
► Dispose of the transport and packaging materials
properly and under ecological aspects.

Installation

When installing the tank, ensure sufficient clearance
from walls and other objects to enable the connection
pipes to be fitted.
6
pallet and during
Subject to change without notice | 83018600hUK – Translation of the original operating manual | ait-deutschland GmbH
Mounting
CAUTION
With our domestic-hot-water tanks, the follow-
ing plastic protective components can be de-
ployed on and in the connections:
● Plastic plugs for internal threads (Protect the
threads and must be removed during installation.
For connections which are not required, they must
be replaced with pressure-resistant plugs):
1 Connecting piece
2 Plastic plug
● Plastic caps for external threads (Protect the
threads and must be removed during installation.
For connections which are not required, they must
be replaced with pressure-resistant caps):
1 Connecting piece
2 Plastic sleeve
NOTE
To level out pressure fluctuations or water
hammer in the cold water network and to
avoid unnecessary water loss, we recommend
installation of a suitable expansion vessel with
flow fittings.