Table of Contents
Advertisement
Japanese notice
Korean notices
Safety
Power cords
The power cord set must meet the requirements for use in the country where the product was purchased. If
the product is to be used in another country, purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. In addition, the diameter of the wire must be a minimum of
2
1.00 mm
or 18 AWG, and the length of the cord must be between 1.8 m (6 ft.) and 3.6 m (12 ft.). If you
have questions about the type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed
upon or against them. Pay particular attention to the plug, electrical outlet, and the point where the cords
exit from the product.
48
Regulatory compliance and safety
Advertisement
Table of Contents
