Keithley DAS-8 Series User Manual page 106

Sample Hold Amplifier
Acquisition time
Dynamic
Reference Voltage Output
Reference
Tempco
Load current
Digital I/O
OP1–4 output
low voltage
OP1–4 output
high voltage
IP1–3 input
low voltage
IP1–3 input
low current
IP1–3 input
high voltage
IP1–3 input
high current
Interrupt Inputs
Type
Level
Enable
Interrupts are latched in an internal flip-flop on the DAS-8. The state of
this flip-flop corresponds to the INT bit (STATUS Register). It is cleared
by a write to the CONTROL Register. Service routines should
acknowledge and re-enable interrupt flop.
A-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
15ms to 0.01%, typ. for full-scale step input
1 bit (2.44mV) @ 2000V/sec sampling error
+10.0V (±0.1V)
50ppm/˚C max., 30ppm/˚C (optional)
±2mA max.
0.5V max. @ 8.0mA (current sink)
2.7V min. @ –0.4mA (current source)
0.8V max.
–0.4 max.
2.0V min.
20µA max. @ 2.7V
Positive (rising) edge triggered
2–7 jumper selectable
Via INT of CONTROL Register
Specifications