Basic Measurements - General WDCFM8912 User Manual

BASIC MEASUREMENT
Basic measured parameters of this model:

BASIC MEASUREMENTS

• Air temp.
• Humidity
• Dew Point
• Wet Bulb
• Air Velocity
EXTENDED MEASUREMENTS
• Air Volume
• Sum of Volume
• Capacity
• Sum of Capacity
When powered on, the air temperature is the default value to show
on the LCD. To review the other basic parameters, just press the
key then each parameter will be displayed in turn.
MODE
While in basic mode, press
measurement mode. You can also press mode key to switch
between volume and capacity.
MAX, MIN & AVG.
When the meter is powered on, air temp., dew-point, WBT, humidity
& velocity is temporarily saved in meter, so, to press L
view the average value minimum value and maximum value in
turns. Press L
re-counted once the meter is powered off and turned on again.
When in Max/Min/Avg
parameters you need. (Fig. A, Fig. B)
(Fig. A)
MODE
Mx/Mn again to back to normal mode. The data will be
, press the
MODE
for over 2 seconds to enter extend
key to display the
MODE
(Fig. B)
Mx/Mn could
5