General WDCFM8912 User Manual page 4

3. ENTER:
- To confirm the setting & calibration.
4. Mx/Mn/Up L
- Pressing to view MAX/MIN/AVG value.
- Press to select the value of each digit in cycle.
5. REC/START:
- To start measuring volume or capacity without waiting.
6. HOLD/Down L
- In basic modes pressing this key to hold the current reading,
then pressing this key again to unlock the holding.
- Pressing to select the setting digit.
7. Power + L
- When the meter is off, pressing more than two sec. to enter
non-sleep mode.
8. Power + L
- Pressing more than two seconds to enter RH calibration mode.
9. ENTER + L
- Pressing to turn on/off the backlight.
O
POWER ON/OFF & UNIT SELECTION
Press to turn on the meter with auto-sleep mode. Press again
to turn off the meter at any mode.
When the meter is off, pressing
units selection mode.
When in unit selection mode, press L
unit then, press
automatically.
4
Mx/Mn :
HOLD :
Mx/Mn :
Mx/Mn +M HOLD :
HOLD :
to save and meter will be powered on
ENTER
O
more than two seconds to enter
or M
Mx/Mn HOLD to select the