Table of Contents
Advertisement
5.2 Wireless Connection
Disconnect all power cables before device installation.
Wireless con guration only works on 2.4GHz systems
For lock wiring refer to section 6
Brown
Brown
Red & White
Black
Red
Black
White
FERMVISION
Yellow
White & Green
Green
White & Orange
Orange
FVP-2020IP
Video door station
1) Connect mobile device into the Wi-Fi network you want to connect outdoor panel;
2) Disable 3G/4G internet connection on your mobile device;
3) Power on the device.
4) Wireless AP mode is identi ed by 1 beep 1 blink every second.
5) Press «CONNECT NEW DEVICE» button, then choose «NEW» check box and press «CONFIRM» button;
6) Press «CONTINUE» button on the mobile device screen to go to the next step;
7) Enter password of the Wi-Fi network which you want to connect to and press «CONTINUE» button;
Note: If the device was originally connected via CAT5/6 LAN cable follow the next steps;
Press&hold call button →
«beep» sound → release call button and quickly press&hold it again
→ second short «beep» sound → release call button and quickly press&hold it again → third double
«beep» → release call button → door station will be restarted and then after a minute you will hear
constant «beeps» sound. It means the door station entered «Access point» mode.
9
Power Supply
240 Vac / +12 Vdc
Dashed line is positive
Solide line is negative
SMA plug for
External
external
Wi-Fi antenna
Wi-Fi antenna
FERMVISION
FERMVISION
7) Fill in device information:
Device Name: any name you like;
Password: 888888 (by default);
then press «CONFIRM» button and you will see added device on the main bar.
FERMVISION
fermaxausIP
fermaxausIP
10
Advertisement
Table of Contents
