Mark PAR 36 ECO Manual

CAUTION. Keep the device away from rain and moisture. Unplug mains lead before opening the housing. For
your own safety, please read this user manual carefully before you initial start-up.
Every person involved with the installation, operation and maintenance of this device have to:
- Be qualified
- Follow the instructions of this manual

INTRODUCTION

- Thank you for having chosen PAR 36 ECO spot. This spot is ideal for party rooms and small discotheques.
- Unpack your PAR 36 ECO
- Before you initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult with your dealer and do not use the device.

SAFETY INSTRUCTIONS

- If the external flexible cable or cord of this sport is damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to avoid a hazard.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an e
xtent that their effectiveness is impaired, for example by cracks or deep scratches.
- The lamp shall be changed if it has become damaged or thermally deformed.
- This device has left our premises in absolutely perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
Important: Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
- If the device has been exposed to drastic temperature fluctuation (e.g. After transporting), do not switch
inmediately. The arising condensation water might damage your device. Leave the device switched off until
it has reached room temperature.
- During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily
mean that the device is defective.
- Do not toucj the device housing bare-handed during its operation (housing become hot)
- Do not switch the pins on and off in short intervals as this would reduce the lamp´s life.
HEALTH HAZARD Nevel look directly into the light source, as sensitive persons may suffer an epileptic shock
- Please considerer that damages caused by manual modifications to the device are not subject to warranty.
Operation DETERMINATIONS This device was designed for indoor use only.
- Do not shaeke the device. Avoif brute force when installing or operating the device.
- You can install the device at any desired place in dry rooms. Please make sure that the device is not
exposed to extreme heat, moisture or dust. There should not be any cables lying around. You endanger
your own and the safety of others.
- Operate the device only after having familirized with its functions. Do not allow an operation by persons
who do not know the device well enough. Most damages are the result of an unprofessional operation.
- Please consider that for safety reasons unauthorized modifications to the device are forbidden.

INSTALLATION

DANGER OF FIRE When installing the device, make sure there is no highly-inflammable material within
a distance of min. 0.5 m
- This device fall under protection class I. Therefore is essential that the yellow/green conductor get
connected to earth.
PAR 36 ECO
EN
Rev. 13.01