Silvercrest SFR 37 B1 Operating Instructions Manual page 10

BB*5$ B%ERRN 6HLWH  0RQWDJ  0DL    
DANGER! Risk of electric shock
~ Only connect the plug-in power unit to a properly installed
and easily accessible wall socket, whose voltage corre-
sponds to the specifications on the rating plate. The wall
socket must continue to be easily accessible after the device
is plugged in.
~ Ensure that the plug-in power unit cable cannot be damaged
by sharp edges or hot surfaces. Do not wrap the plug-in
power unit cable around the device.
~ When using the device, ensure that the plug-in power unit
cable cannot be trapped or crushed.
~ When removing the plug-in power unit from the wall socket,
always pull the plug and never the cable.
~ Pull the plug-in power unit out of the wall socket, ...
... if there is a fault,
... when you are not charging the device, and
... during thunderstorms.
~ Do not use the device if there is visible damage on the de-
vice, the plug-in power unit, or the corresponding cable.
~ If the plug-in power unit or the corresponding cable of this
device are damaged, they must be replaced by the manufac-
turer or its customer service department or a similarly quali-
fied person, to prevent any hazard.
DANGER from batteries
~ Do not expose the device to direct sunshine or heat. The am-
bient temperature should not be lower than 0 °C or higher
than +40 °C.
~ The charge contacts on the device must not be connected by
metallic objects.
8
GB