Battery Installation - VESALA NanoSonde MPL4-33 User Manual

NanoSonde® MPL4-33
The serial number of your device is indicated on your Sonde and also on the
storage case. The serial number may wear off, enter the serial number below and
always refer to this information when you need to contact the manufacturer.
VERSION NUMBER
SERIAL NUMBER
IMPORTANT SAFETY INFORMATION
The following symbol is used throughout this manual mark important instructions.
Please take care when meeting this symbol:
GENERAL INFORMATION
The NanoSonde MPL4-33 is a very small, battery operated transmitter that emits a
33 kHz signal, which can be located by a receiver operating on the same
frequency. The NanoSonde is intended to be used in non-conductive ducts,
cavities and structures. The flexible construction allows the Sonde to pass through
curves and bends. The device is intended for professional use.
ITEMS SUPPLIED
1 NanoSonde
1 Shock Absorber
1 Spare Battery Cap
2 Lithium Battery
1 Case with Quick Reference Guide

BATTERY INSTALLATION

When the battery cap is correctly closed, the locking mechanisms of the battery
cap are visible in the slots by the closed lock symbol (Figure 1). Turn the battery
cap 90° or a quarter turn clockwise (Figure 2). Each quarter turn will be indicated
by an audible click. The locking mechanism will now be visible in the opening by
the open lock symbol (Figure 3). Remove the battery cap by pulling it gently.
Figure 1: Closed battery cap
Turning the battery cap counterclockwise will damage the battery cap
and/or Sonde.
Precaution: Always take care to turn the battery cap clockwise
1(6)
X00
___________________________
Figure 2: Opening battery cap
MPL4-33
IV343-48
MPL4-BC
BR425
SB4
Figure 3: Open battery cap