Table of Contents
Advertisement
3.5 Powering On
1. Plug in all the power cords into the AC Power Input Socket located at the PSFM.
NOTE: The subsystem is equipped with redundant, full range
power supplies with PFC (power factor correction). The system
will automatically select voltage.
NOTE: The PSFM has a 5V standby DC voltage. When the power
cord(s) is/are connected to the AC Power Input Socket, after 1
second, all Activity LEDs will flash once. When the power cord(s)
is/are disconnected from AC Power Input Socket, after 3 seconds,
all Activity LEDs will flash twice.
2. Turn on each Power On/Off Switch of the PSFM. The main switch button in the
front panel will still flashing blue.
NOTE: When the power cord connected from main power source is
inserted to the AC Power Input Socket, the Power Status LED
becomes RED. When the switch of the PSFM is turned on, the LED
still shows RED. After the main switch in front panel is turned on,
the LED turns GREEN, which means it is functioning normally.
Power Supply 1
64 Bays SAS to SAS/SATA JBOD Subsystem
Power Supply 2
User Manual
39
Advertisement
Table of Contents
