Wiring Diagram - Makita DUB361 Technical Information

W
iring diagram
Fig. D-2
Put Lead wires of Switch
unit between Ribs C and D.
Rib E
Rib F
Terminal A
Battery capacity
warning lamp A
Put the following Lead wires between Ribs E and F.
* Lead wires (red, black, yellow) of Terminal A
* Lead wire (red, black) of Battery capacity warning lamp A
Wiring to Terminal
Flag connector
Terminal A
Set Flag connectors to Terminals A and B
as shown above.
Put Battery capacity warning lamps A and B
while facing their wires connected portion to
Terminals A and B side.
Battery capacity warning lamp A
Wiring diagram in Housing (L)
Do not put any Lead wires
between Ribs A and B.
Rib C Rib A Rib B
Rib D
Be careful not to put
any Lead wires
on these Ribs.
Terminal B
Battery capacity
warning lamp B
Flag connector
Terminal B
Setting of Battery capacity warning lamps A, B
Battery capacity warning lamp B
Put the following Lead wires with
these Lead wire holders.
* Endbell's Lead wires (black, red)
* Controller's Lad wires (black, red)
Put Closed end splices and
Line filter here.
Setting of Terminal to Housing (L)
Terminal A
Terminal B
Set Terminals A and B to Housing (L)
as shown above.
Terminal A
P 6/ 6
Closed end splice
Line filter
Terminal B