DAD DXZ48 User Manual page 9

DXZ48
9
EN
2.1 . Gain
Adjust the gain by dialing the rotary encoder. The gain is adjusted in steps of 0.25dB. Smaller steps (0.01dB)
can be set via the PC or MAC interface.
2.2 . Input Selection
Select the source (Analog) by rotating the encoder.
2.3 . Channel Link
By linking 2 channels, the settings are guaranteed to be identical for both channels, except for mixer and
mute. Turn the encoder to set the Channel Link on or off.
Output Setup
3 .
Press the Channel Up or Down button to select the output channel you wish to edit. Make the first settings
with the output turned low or muted.
To toggle through the different items, press the Item Up or Item Down buttons.
3.1 . Gain
Adjust the gain by dialing the rotary encoder. The gain is adjusted in steps of 0.25dB. Smaller steps (0.01dB)
can be set via the PC or MAC interface.
3.2 . Mixer
Turn the rotary encoder to mix the signal from the selected input to the selected output. Push the rotary
encoder to select the input. Attention: The mixer is only available while the outputs are not linked by
Channel Link. If the channels are linked, the mixer will be skipped.
3.3 . Delay
Set the delay time by turning the encoder. Select the displayed unit (ms or s, mm or m, feet, inches, or mils)
by pushing the encoder.