Sentera STL Series Mounting And Operating Instructions
  1. Manuals
  2. Brands
  3. Sentera Manuals
  4. Controller
  5. STL Series
  6. Mounting and operating instructions

Sentera STL Series Mounting And Operating Instructions

Electronic fan speed controller, 230 vac
Hide thumbs
Table of Contents

Advertisement

Quick Links

STL
ELECTRONIC FAN SPEED
CONTROLLER, 230 VAC
Mounting and operating instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STL Series and is the answer not in the manual?

Questions and answers

Related Manuals for Sentera STL Series

Summary of Contents for Sentera STL Series

  • Page 1 ELECTRONIC FAN SPEED CONTROLLER, 230 VAC Mounting and operating instructions...

  • Page 2: Table Of Contents

    ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS WIRING AND CONNECTIONS OPERATIONAL DIAGRAMS MOUNTING INSTRUCTIONS IN STEPS VERIFICATION OF INSTALLATION INSTRUCTIONS TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-STL-EN-002 - 30 / 07 / 2018 2 - 8 www.sentera.eu...

  • Page 3: Safety And Precautions

    In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-STL-EN-002 - 30 / 07 / 2018 3 - 8 www.sentera.eu back to the table of contents...

  • Page 4: Product Description

    Protection standard: IP54 (according to EN 60529) ■ Operating ambient conditions: temperature: 0—35 °C ► ► rel. humidity: < 95 % rH (non-condensing) ■ Storage temperature: -40—50 °C MIW-STL-EN-002 - 30 / 07 / 2018 4 - 8 www.sentera.eu back to the table of contents...

  • Page 5: Standards

    Make sure the STL controller is switched off and the power is disconnected. Unscrew the front cover and open the enclosure. Mind the two wires that connect the potentiometer with the printed circuit board. MIW-STL-EN-002 - 30 / 07 / 2018 5 - 8 www.sentera.eu back to the table of contents...
  • Page 6 Make sure that the connections are correct before you power the unit. Set the potentiometer at Min. speed position and switch on the controller. MIW-STL-EN-002 - 30 / 07 / 2018 6 - 8 www.sentera.eu back to the table of contents...

  • Page 7: Verification Of Installation Instructions

    ► the trimmer has been set in the desired position; ► all connections are correct; ► ► the regulated device is functioning. MIW-STL-EN-002 - 30 / 07 / 2018 7 - 8 www.sentera.eu back to the table of contents...

  • Page 8: Transport And Storage

    Only reconnect it to the supply when it is completely dry. Use only fuses with type and rating specified above; otherwise, loss of warranty ATTENTION will ensue. MIW-STL-EN-002 - 30 / 07 / 2018 8 - 8 www.sentera.eu back to the table of contents...

This manual is also suitable for:

Stl-0-30-atStl-0-60-atStl-0-15-atStl-0-50-atStl-0100-at

Table of Contents