Page 1
ELECTRONIC FAN SPEED CONTROLLER Mounting and operating instructions...
Page 2
TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAMS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS TRANSPORT AND STOCK KEEPING INFORMATION WARRANTY INFORMATION AND RESTRICTIONS MAINTENANCE MIW-MTX-EN-000 - 02 / 12 / 2015 2 - 7 www.sentera.eu back to the table of contents...
Page 3
In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-MTX-EN-000 - 02 / 12 / 2015 3 - 7 www.sentera.eu back to the table of contents...
Page 4
Several motors can be connected as long as the current limit is not exceeded. ARTICLE CODES OUTPUT REGULATION FROM MINIMUM TO MAXIMUM Code Current range, [A] Fuse, [A] (5*20 mm) MTY-0-05-AT 0,05—0,5 F-0,63 A-H MTY-0-15-AT 0,1—1,5 F-2,00 A-H MTY-0-25-AT 0,2—2,5 F-3,15 A-H MTY-0-40-AT 0,4—4,0 F-5,00 A-H OUTPUT REGULATION FROM MAXIMUM TO MINIMUM...
Page 5
“Wiring and connections”. Fig. 1 Wiring and connections Fuse holder with a spare fuse Minimum speed adjustment trimmer 230 VAC 230 VAC MIW-MTX-EN-000 - 02 / 12 / 2015 5 - 7 www.sentera.eu back to the table of contents...
Page 6
Push the knob in place at off position. You can drill a hole (5 mm) at the bottom of the external enclosure to take away NO T E condensed water. MIW-MTX-EN-000 - 02 / 12 / 2015 6 - 7 www.sentera.eu back to the table of contents...
Page 7
Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-MTX-EN-000 - 02 / 12 / 2015 7 - 7 www.sentera.eu back to the table of contents...
This manual is also suitable for:
Mty-0-05-atMty-0-25-atMtx-0-15-atMtx-0-05-atMtx-0-25-atMtx-0-40-at...
Show all
Need help?
Do you have a question about the MTY-0-15-AT and is the answer not in the manual?
Questions and answers