Changing From Tone To Pulse Dialing - Uniden AS1051 Series User Manual

Connect the charger
1. Connect a charger AC adapter to each charger's power jack and
set the plug into the notch as shown.
(These adapters might already be
connected.)
2. Plug the other end of the adapter into a
standard AC power outlet.
3. Place each handset in a charger with
the display facing forward. The
If...
the
CHARGE
light doesn't
turn on
Charge all handsets completely (about 15 hours)
before using them.
Test the connection
Pick up each handset and press
and the display should say Talk. (Press
If you can't get a dial tone or the handset display says Unavailable, try
moving the handset closer to the base or resetting it (see page 27).

Changing from Tone to Pulse Dialing

Phones can communicate with the telephone network in two different
ways: tone (DTMF) or pulse dialing. If you know your phone company
uses pulse dialing or you can't make your test call, follow these steps:
1. With the phone in standby, press
2. Use or
UP DOWN
3. Use or
UP DOWN
4. Highlight Pulse, then press
confirmation tone. Try making another test call.
If you use pulse dialing and you need to send DTMF tones during a
call (if you're using an automated response system, for example),
press to temporarily switch to tone dialing. When the call ends, the
phone automatically returns to pulse dialing mode.
4
CHARGE
Try...
- reseating the handset.
- checking the AC adapter connection.
- seeing if the outlet is controlled by a wall
switch.
. You should hear a dial tone
TALK
MENU/SELECT
to highlight Global Setup, then press
to highlight Dial mode, then press
MENU/SELECT
light should turn on.
to hang up.)
END
.
MENU/SELECT
MENU/SELECT
. The phone sounds a
.
.