REDT R&D MAGIC-70 Manual page 5

Cautions related to use

Do not allow any part of body or
other objects onto the engraver.
 The cutter of engraver may
cause serious injury during its
operation.
Be sure not to be caught or
jammed between the paths of
each axis of the engraver, or
scratched by the engraving cutter.
 It may cause serious injury, or
damage or failure of the
engraver.
Other cautions

Do not disassemble or modify the
engraver.
 It may cause fire, electric
shock or failure. Please
contact the sales agency or
our service center for
Inspection, calibration and
repair.
During winter, when temperate are
fall below the freezing point, the
product may not be normally
perform. In this case, please keep
the temperature in the place where
you use this engraver for normal
operation. Please make sure the
temperature in the place where
you use the engraver does not fall
below the freezing point.
Do not put water or small metal
materials on the engraver.
 Due to negligence or vibration
of the engraver, the materials
may fall and cause injury, fire
or failure by overheating or
short circuiting.
 If water gets into the product,
it may cause electric shock or
fire.
Laser Radiation
Avoid eye or skin exposure to
direct or scattered radiation.
Class 1 laser product.
Be sure to keep out of the reach of
toddlers and children. Their
curiosity or carelessness may
cause injury.
4