Precautions - Sony MVC-FDR1, MVC-FDR1E Operating Instructions Manual

Precautions

On cleaning
Cleaning the LCD screen
Wipe the screen surface with a LCD cleaning kit (not supplied) to remove fingerprints,
dust, etc.
Cleaning the surface
Clean the surface with a soft cloth slightly moistened with water. Do not use any type of
solvent such as alcohol or benzene as it may mar the finish of the casing.
Concerning floppy disks
To protect data recorded on floppy disk, note the following:
• Avoid storing floppy disks near magnets or magnetic fields such as those of speakers
and televisions, permanent erasure of disk data may result.
• Avoid storing floppy disks in areas subject to direct sunlight or sources of high
temperature, such a heating device. Floppy disk warping or damage may result,
rendering the disk useless.
• Avoid contact with the disk's surface by opening the disk shutter plate. If the disk's
surface becomes blemished, data may be rendered unreadable.
• Avoid dropping liquids on the floppy disk.
• Be sure to use a floppy disk case to ensure protection of important data.
• Use only a 2HD type disk head cleaner when cleaning the disk drive.
• Even when you use a 3.5-inch 2HD floppy disk, image data may not be recorded
and/or displayed depending on the using environment. In this case, use other brand
disks.
Operational temperature recommendations
This unit's operational temperature is between 32°F to 104°F (0°C to 40°C). Do not use
this unit in extreme climates such as that of a hot beach or a skiing resort.
Moisture condensation
If the unit is brought directly from a cold to a warm location, or is placed in a very
damp room, moisture may condense inside or outside the unit. Should this occur, the
unit will not operate properly. In this case, remove the floppy disk, turn off the unit,
and wait about an hour for the moisture to evaporate.
28
-EN