Loudspeaker Volume - Shure DDS 5900 Manual

DDS 5900 Digital Discussion System Shure Incorporated
Adjusts the level of the line input 1 signal.
<gain> Adjust line input gain to 0 or 10 dB.
The CCU responds to this command by issuing the line_input_gain_1 command.
Set Line Output Volume (A-D)
line_output_volume <output> <volume><CR>
Adjusts the level of the line output signal.
<output> Indicates which output is being controlled. Possible values are: 'A', 'B', 'C' or 'D'.
<volume> The volume of the line output ranges from -41 to 0. The value -41 indicates the volume is Off. Values
from -40 to 0 indicate attenuation in dB.
The CCU responds to this command by issuing the line_output_volume command.
Define Audio Path
audio_path <path> <on/off><CR>
This command defines audio connections in the system.
<path> Indicates which connection is being controlled. Possible values are: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A' or 'linein_1_to_floor'.
<on/off> Indicates whether the audio is being routed from microphones/lineinput_1 to speakers/lineoutput/floor.
The CCU responds to this command by issuing the audio_path command.
Request Audio Status
audio_status<CR>
Provides system audio status.
The CCU responds to this command by issuing a list of commands for the Audio settings:
loudspeaker_volume
line_output_volume (for all outputs A-D)
audio_path (for all paths)
line_input_level
audio_status_done
Commands from DIS-CCU to External Control

Loudspeaker Volume

loudspeaker_volume <volume><CR>
76/96