Supply Voltage - S+S Regeltechnik AERASGARD RCO2-W Manual

G
Mounting and Installation

SUPPLY VOLTAGE :

For operating voltage reverse polarity protection, a one-way rectifier or
reverse polarity protection diode is integrated in this device variant.
This internal one-way rectifier on AC supply voltage.
The output signal is to be tapped by a measuring instrument. The output
signal is measured her against zero potential (O V) of the input voltage!
When this device is operated on DC supply voltage , the operating voltage
input UB+ is to be used for 15...36 V DC supply and UB – or GND for
ground wire!
When several devices are supplied by one 24 V AC voltage supply, it is to
be ensured that all "positive" operating voltage input terminals (+) of the
field devices are connected with each other and all "negative" operating
voltage input terminals (–) (= reference potential) are connected together
(in-phase connection of field devices). All outputs of field devices must be
referenced to the same potential!
In case of reversed polarity at one field device, a supply voltage short-
circuit would be caused by that device. The consequential short-circuit
current flowing through this field device may cause damage to it.
Therefore, pay attention to correct wiring!
Humidity table
MR: 0...100 % r. H.
% U I
A A
r.H. in V in mA
0 0 4.0
5 0.5 4.8
10 1.0 5.6
15 1.5 6.4
20 2.0 7.2
25 2.5 8.0
30 3.0 8.8
35 3.5 9.6
40 4.0 10.4
45 4.5 11.2
Continued at the right ...
% U I
A A
r.H. in V in mA
50 5.0 12.0
55 5.5 12.8
60 6.0 13.6
65 6.5 14.4
70 7.0 15.2
75 7.5 16.0
80 8.0 16.8
85 8.5 17.6
90 9.0 18.4
95 9.5 19.2
100 10.0 20.0
Connecting scheme
Power supply
AC 24V~ 0V
DC 15-36V = GND
Connecting scheme
Power supply
AC 24V~ 0V
DC 15-36V = GND
Temperature table
MR: 0...+50 °C
°C U
A
in V in mA
0 0
5 1.0
10 2.0
15 3.0
20 4.0 10.4
25 5.0 12.0
30 6.0 13.6
35 7.0 15.2
40 8.0 16.8
45 9.0 18.4
50 10.0 20.0
15
Individual operation
Circuitry
Parallel operation
Circuitry Circuitry
I
A
4.0
5.6
7.2
8.8