Download  Print this page

Industry Canada Notice - Sony BTA-NW1A Operating Instructions Manual

Modem adaptor with bluetooth function
Hide thumbs

Advertisement

Table of Contents
The REN is used to determine the quantity of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all areas, the sum of the RENs
should not exceed five (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company
to determine the maximum REN for the calling area.
If the terminal equipment (MDM-5614G exclusive modem card) causes harm to the
telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn't practical, the
telephone company will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operations of the equipment. If this happens, the
telephone company will provide advance notice in order for you to make the necessary
modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment (MDM-5614G exclusive modem card),
please contact 1-800-222-SONY (7669), or write to the Sony Customer Information
Service Center, 12451 Gateway Blvd., Fort Myers, Fl 33913 for repair and (or) warranty
information. If the trouble is causing harm to the telephone network, the telephone
company may request you remove the equipment from the network until the problem
is resolved.
Repair of this equipment should be made only by a Sony Service Center or Sony
authorized agent. For the Sony Service Center nearest you, call 1-800-222-SONY (7669).
This equipment cannot be used on public coin service provided by the telephone
company. Connection to Party Line Service is subject to state and possible provincial
tariffs. (Contact the state or provincial utility service commission, public service
commission or corporation commission for information.)
For the Customers in CANADA
Operating Condition
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding. Equipment
(or its transmit antenna) that is installed outdoors is subject to licensing.

INDUSTRY CANADA NOTICE

The term "IC:" before the radio certification number only signifies that Industry Canada
technical specifications were met.
NOTICE: The Industry Canada label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protective,
operational and safety requirements as prescribed in the appropriate Terminal
Equipment Technical Requirements document(s). The Department does not guarantee
the equipment will operate to the user's satisfaction.
3-
GB

Advertisement

Table of Contents
loading

  Related Manuals for Sony BTA-NW1A