Makita 8280D Technical Information page 3

R
epair
[2] Removal/Installation of Motor from/on Gear Assembly (cont.)
INSTALLATION
1) Place Motor bracket as illustrated in Fig. 5,
and fasten it to Motor with two Pan head
screws.
2) Aligning the protrusions on Motor bracket
with the grooves in Gear assembly,
assemble Motor to Gear assembly. (Fig. 6)
3) Assemble Motor to Gear assembly while
turning it in the clockwise direction when
viewed from the terminal end of Motor.
(Fig. 7)
Fig. 6
Protrusions on
Motor bracket
[3] Installing Speed change Lever
1) Make sure that two Compression springs are set in place on Speed change lever
as illustrated in Fig. 8.
2) Install Speed change lever onto the protrusion on Gear assembly as illustrated
in Fig. 9.
After installation, slide Speed change lever to either side. (Fig. 10)
Fig. 9
Speed change lever
Protrusion
Fig. 5
Place Motor bracket
so that its protruding
side is positioned on
the opposite side to the
red marking on Motor.
Pan head screw
Grooves in Gear assembly
Gear assembly
Motor bracket
Motor
Protrusion
Gear assembly Motor
Side without protrusion
Motor bracket
Fig. 7
Gear assembly
Fig. 10
Compression
springs
Speed change lever side
Red marking
Protruding side
Trigger switch side
Terminals
Motor
Fig. 8
Compression springs
Speed change lever
Speed change
lever
P 3 / 5
Motor