Advertisement
E T C P r o g r a m m i n g G u i d e
N o t e :
Setting Intensity Level
• Pushing the test button will cause the fixture to enter test mode. This is true even if the current user
interface is showing the DMX channel on the display. The current 0-100% light output level will be
shown on the three digit screen. There is no time-out for test mode.
• Pressing and holding the test button will execute a test fade from 0-100%
• To exit test mode, press and release the test button. When exiting test mode the screen will go
blank, DMX control will be restored and the dimmer will return to the current DMX address.
RDM and User Interface Error Notifications
• Over Current Notification - Output wiring short
• No Load Notification - Lamp has burned out or has been removed
• Over-temp - Fixture has exceeded operating temperatures and will shut down
N o t e :
Switching Output Voltage
The dimmer can be configured to output 230V in place of the default 115V.
To view the current output voltage:
Step 1:
To change the current output voltage:
Step 1:
Step 2:
Once the countdown is complete, the new voltage will be applied and saved.
W A R N I N G :
Sou rc e Fo ur Dimme r Pr og ra mmi ng Gu id e
If data loss is detected, the lamp output will be held at the last level specified.
Dimmer will automatically re-enable when fixture is back within operational
temperature range. No user intervention is required to clear the error.
LED Statu s Indicator
LED Color
Solid Green
Slow Blinking Green
Fast Blinking Green
Solid Red
Press and hold both the plus and minus buttons. The output voltage will be shown on the
three digit display.
Press and hold both the plus and minus buttons.
While holding the plus and minus buttons, hold down the test button. The voltage that you
will be changing to will appear blinking, then a 5-count, count down will be shown.
Make sure your lamp voltage matches your dimmer voltage. Default dimmer output
regulates to 115V at 100%. A dimmer set to 230V will damage a 115V lamp.
Source Four Dimmer/ES750/ES1
Description
Normal operation
No DMX detected
Invalid or incorrectly wired DMX
Error condition exists
Page 2 of 3
El ect r on ic T he at r e Con tr o ls , I nc.
Advertisement
