Level Adjustment - LG WD-N1213D6 Owner's Manual

I nstallation

Level adjustment

Adjustable Adjustable
feet feet
In case of auto leveling foot
12
1. Adjusting the washing machine level properly prevents excessive
noise and vibration.
Install the appliance on a solid and level floor surface, preferably
in a corner of the room.
Timber or suspended type flooring may contribute to
NOTE
excessive vibration and unblance errors.
2. If the floor is uneven, adjust the adjustable feet as required.
(do not insert pieces of wood etc. under the feet)
Make sure that all four feet are stable and resting on the floor and
then check that the appliance is perfectly level. (use a spirit level)
※ ※ After the washer is level, tighten the lock nuts up towards of the base of
the washer. All lock nuts must be tightened.
In the case that the washing machine is installed on a raised
NOTE
platform, it must be securely fastened in order
to eliminate the risk that it might fall off.
❊ Diagonal Check
When pushing down the edges of the washing machine top plate
diagonally, the machine should not move up and down at all. (Please,
check both of two directions)
If machine rocks when pushing the machine top plate diagonally,
adjust the feet again.
Auto leveling foot is applied to the right rear part of washing machine.
Different from adjustable feet, adjusting auto leveling foot's bolt might
cause noise or vibration.
❊ Check the auto leveling foot's state
Case1. Floating from floor
• Make auto leveling foot pressed by loosening
adjustable feet of left front side.
Case2. Auto leveling foot fully pressed
• Make auto leveling foot released by loosening
adjustable feet of right front and left back sides.