Safety Instructions; Before Initial Operation - Elma Modulgrav Operating Instructions Manual

2.
Safety Instructions / Regulations
The device is intended exclusively for the engraving of metal and plastic surfaces and
-
for surfaces of artificially manufactured material.
When operating the milling module, make sure that nothing gets into the operating area
-
of the miller (rotating parts) or severe injuries may occur. This applies specifically to hair
and fingers. The miller may not be slowed down with the fingers.
During milling, safety goggles must be worn to protect the eyes from facings.
-
3.

Before Initial Operation

Please check the device for possible transportation damage. Such damage cannot
-
always be detected by looking at the shipping box. If the device shows any damage,
please contact Elma to clarify claims settlements.
Remove all safety devices which were necessary for transportation.
-
The device may only be installed and used on a dry, level and solid surface.
-
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
Quality from Tradition; Technology of Tomorrow
4