Table of Contents
Advertisement
OPERATION
M
S
AIN
CREEN
Figure 7: Smart Touch Main Screen Icon Functions
1.
Mode Icon Indicator - The Mode icon indicates the current mode active. Press and release to select one of the four
operating modes. Continue to press and release the Mode Icon until the desired operating mode is reached. The mode
icons (Auto, Cool, Heat, Auxiliary Heat, or Moisture) light to indicate which mode is selected. It shows 5 different icons
depending on the mode:
•
Auto Mode Icon Indicator - The Auto Mode icon is shown when the system is in Automatic Mode, which switches
to cooling or heating as required to satisfy the temperature set point.
•
Cool Mode Indicator - The Cool Mode icon is shown when the cool-only mode is selected or when the unit is in
an Automatic Mode cooling cycle.
•
Heat Mode Indicator - The Heat Mode icon is shown when the heat-only mode is selected or when the unit is in
an Automatic Mode heating cycle.
•
Auxiliary Heat Mode Indicator - The Auxiliary Heat Mode icon is shown when the Aux heat-only mode is
selected or when the unit is in an Automatic Mode Auxiliary heating cycle.
•
Moisture Mode Indicator - The Moisture Mode icon is shown when the Moisture Mode is selected. This mode
controls humidity during periods when the vessel is unoccupied.
2.
Fan Mode Indicator - Auto or Manual Indicator icon shows when Automatic fan speed or either of the three Manual
speeds are selected.
3.
Power Icon - Press and release to toggle between the On and Off Modes.
4.
Up Icon - Press and release to display the set point. Press and release the Up icon as many times as desired to
increase the set point. Set point increases one degree each time the icon is pressed.
5.
Down Icon - Press and release to display the set point. Press and release the Down icon as many times as desired to
decrease the set point.
6.
Fan Icon - Fan-speed operation is automatic, allowing fan speed to decrease as set-point temperature is approached
in the Cool Mode. The fan operates at low speed when set point is satisfied. Normally the automatic fan speed
operation is reversed in the Heating Mode; however, you can program the fan to operate the same as in the Cooling
Mode. Press the Fan icon to select manual fan speeds if you want to override automatic operation. You can program
the fan to run only during a cool or heat cycle; otherwise the fan runs constantly. Press and release to advance from
Auto Fan to Manual Fan. Press and release the Fan Icon to advance the manual fan speeds, from low to high. Press
and release again to return to the Automatic Fan mode. The selected Fan Mode is indicated by the Fan Indicator icon.
You can change the fan operating mode from Continuous to Cycled by going to Main Menu, Control Parameters,
General Settings, and then Fan Operate Mode.
7.
Temperature Set Point and Humidy Indicator Icon - Press and release to select from Set point(s), Inside, Outside,
or Service/Water temperatures and Humidity.
8.
Main Menu Icon - Press the Menu icon to show the Main Menu page.
9.
Status/Schedule Icon - Press the Status/Schedule icon to view any fault occurring in the system.
10. Dometic/Date/Time Icon - This shows the date and time if enabled. To enable it, press Menu, Date/Time Menu, and
then Date/Time Display.
8
I
F
CON
UNCTIONS
10
1
6
8
2
Smart Touch Cabin Control Installation & Operations Manual
4
5
7
3
9
L-3380 ENGLISH
Advertisement
Table of Contents
