Reinstate To Normal Mode And Automatic Memory - CipherLab 1166 Manual

Reprogram to normal mode
This page is not part of a regular schedule. This mode is only used if the settings are lost or deleted, perhaps through
computer malfunction or incorrect programming.
Do not use to change user memory modes.
Scan following barcodes in order.
Step Action
1 Scan Enter Setup
2 Scan Restore Default Settings
3 Scan Transmit Buffer Setting
4 Scan Scan Buzzer Setting 2 Khz
5 Scan Update
6 Wait for a long beep, then a couple of shorter delayed beeps.
7 Scan Enter Setup
8 Scan Inter-Character Delay
9 Scan *0
10 Scan 8
11 Scan Validate
12 Scan Update
Wait for above beeps, then test by scanning book barcodes into Microsoft Word.
If this fails scan the two barcodes under the cradle (these may require patience), "Set Connection" first, then
"AH.......barcode". If either barcode appears in Microsoft Word then rescan.
(Live transmission, automatic memory, as first supplied)
Page 6 of 6
Barcode