General; Location And Function Of Controls - Sony Trinitron Multiscan CPD-1302 Service Manual

SECTION 1
GENERAL
CPO-1302
,-,_ LOCATION AND FUNCTION OF CONTROLS
On the Iront panel
On the rear panel
I~~.r----,rn
j""==---:=------1[!]
m
POWER switch and indicator (green)
display stand
(optional)
To turn on the power of the unit, press this switch to ON. The Indi-
cator will light up. To turn off the unit, press towards OFF.
8
0N
o
ld
OFF
rn
PICTURE control
Adjusts the contrast. Turn downwards to increase contrast, or up-
wards for less contrast.
rn
BRIGHTNESS control
Normally keep this control at the center detent position. For a brighter
display, turn this knob downwards, or for a darker display, turn It
upwards.
- f i -
Push upward
to remove panel.
m
H SHIFT (horizontal shift) control
Turn this control to center the displays of microcomputers, charac-
ter generators, etc. that are shifted toward the left or right side of
the screen.
[[) V SHIFT (vertical shift) control
Turn this control to eliminate any shifting in the vertical direction.
[I]
H SIZE (horizontal size) control
Turn this control to adjust the horizontal size.
rn
V SIZE (vertical size) control
Turn this control to adjust the vertical size.
[[) RGB Input selectors
Depending on the RGB output of the equipment you have connect-
ed, set these switches to one of the following four positions.
ANALOG: For microcomputers
having analog RGB output, such
as those using the PGA card.
The position of the left switch
has no effect when the right
switch is set to ANALOG.
NORM-DIGITAL: For microcom-
puters having TIL RGB output,
such as the IBM 3270.
D1-DIGITAL: For mIcrocom-
puters having TIL RGB and I
signal output, such as the IBM
PC, AT and XT using the stand·
ard color graphics card.
D2-DIGITAL: For TIL graphics
cards on the IBM PC, AT and
XT. (automatic adjustment be·
tween EGA, CGA and MDA)
1 1 012
NORM 01
I ~ I
NORM 01
d2
~I
I
DIGITAL
C@]
ANALOG
I
DIGITAL
W£J
ANALOG
ill
RGB IN (Input) connector (S-pln D-sub)
Allows a microcomputer having either analog or digital RGB output
to be connected.
Refer to page 8.
11m
AC IN connector
Connect to the AC outlet with the supplied AC power cord.