Resetting The Accumulated Battery Use Time Indication; Setting The Rf Output Level - Sony UWP-C1/C2 Operating Instructions Manual

Settings
Resetting the
accumulated battery
use time indication
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1) and
the portable diversity tuner
(URX-P1).
The accumulated battery use time is
the total time (in hours and minutes)
that the batteries have been used. It is
recorded whenever the transmitter/
microphone/tuner is on.
Reset the indication to "00:00"
whenever you replace the batteries.
1
For transmitters (UTX-B1/H1)
-a
Turn on the unit while pressing
down the SET button.
1
For the portable diversity
-b
tuner (URX-P1)
Press down the SET button for
more than one second.
Keep pressing the SET button
until the display section
parameters start to flash.
2
Press the SET button repeatedly
until the accumulated time
indication appears in the display
section.
32
3
Press the – button.
The time indication resets to
"00:00."
While "00:00" is still displayed,
you can return to previous value
by pressing the + button.
4
For transmitters (UTX-B1/H1)
-a
Set the POWER switch to OFF to
complete the setting, or press the
SET button to set other items.
The results are stored in memory.
The change becomes effective the
next time you turn on the unit by
setting the POWER switch to ON.
4
For the portable diversity
-b
tuner (URX-P1)
Leave the tuner for about 10
seconds until the time indication
stops flashing and the setting is
stored in memory.
Setting the RF output
level
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1).
You can select an RF output level of
H (10 mW) or L (2 mW) in setting
mode. Set the RF output level to L (2
mW) for simultaneous operation of
multiple channels, and set it to H (10
mW) for long-distance operation.
1
Turn on the transmitter while
pressing down the SET button.