JEFF ROWLAND Conductor Manual page 22

Low output Moving Coil cartridges (LOMC) -position 1 and 2
ON
Standard Moving Coil cartridges (MC)
ON
High Output Moving Coil cartridges
ON
Moving Magnet cartridges
ON
Two RCA interconnect cables are provided to connect between
the audio source component and selected CONDUCTOR input.
Connect the chosen source component output to the Network
RCA inputs labeled R IN and L IN with one supplied RCA cable.
Use the other supplied RCA cable to connect the Network R
OUT and L OUT RCA outputs to any active right and left channel
CONDUCTOR RCA input jacks.
Turn on the source component with a verified signal, then turn on
the CONDUCTOR and choose the selected active input. Monitor
the CONDUCTOR outputs with a connected preamplifier to
verify that the source signal is present. The source component can
be left on, providing a constant "break-in" signal whenever the
phono turntable is not being used, to facilitate a complete break-
in of all internal circuitry of the CONDUCTOR. Expect dramatic
improvements of the CONDUCTOR sonic performance after 400
hours or more of "break-in" using this Inverse RIAA network.
! 2 2
-position 3 and 4
-position 5 and 6
-position 7 and 8