Introduction; About The Xtp Pi 400 - Extron electronics XTP PI 400 User Manual

Introduction

This guide contains information about the Extron XTP PI 400 power injector with instructions
for experienced installers on how to install, configure, and operate the equipment.
In this guide, the term "XTP PI 400" is used to refer to the XTP PI 400 Power Injector.
This section provides basic information about this guide, the XTP PI 400, and key features
of the XTP PI 400. Topics in this section include:
•
•

About the XTP PI 400

The Extron XTP PI 400 power injector provides power for up to four PoE compatible devices
such as XTP extenders, IP Link Pro control processors, MediaLink Plus controllers, or
TouchLink Pro touchpanels. It eliminates the need for local power supplies.
Designed specifically for the high data rates of XTP systems, signal quality is unaffected
when using the power injector. It can be installed anywhere within the XTP signal path,
providing design flexibility for remote devices with limited space. The XTP PI 400 also
provides integration flexibility in XTP systems with fully populated matrix switchers.
To ensure quick and dependable installation, the 1U, half rack width enclosure can be
securely mounted using Extron rack shelves.
PS 1210
Desktop Power
Supply
Figure 1.
About the XTP PI 400
Features
XTP R HDMI
Receiver
POWER
12V
XTP T HDMI
Transmitter
POWER INPUTS
12V
--A MAX
HDMI LOOP-THRU
PS 1210
Desktop Power
Supply
XTP Signal
100-240V x.xA
XTP PI 400
50/60 Hz
XTP Power Injector
INPUTS
POWER AUDIO
AUDIO
12V
L
--A MAX ON
OFF
HDMI LOOP-THRU + −
XTP T HDMI
Transmitter
Typical XTP PI 400 Point-to-point Application
XTP R HDMI
Receiver
ACT ACT LINK LINK
PS 1210
SIG LINK
AUDIO AUDIO OVER XTP
ON L R RS-232 IR
RESET
Desktop Power
OFF
+ − + − Tx Rx G Tx Rx XTP OUT ACT LINK
LAN
Supply
XTP Signal
XTP Signal
1 2 3
PWR PWR PWR
XTP XTP PWR XTP XTP PWR XTP XTP PWR
Remote Power
SIG LINK
OVER XTP
R
RS-232 IR RESET
+ −
Tx Rx G Tx Rx XTP OUT ACT LINK
LAN
AUDIO
ON
OFF
XTP IN XTP IN Tx Rx HDMI
XTP R HDMI
Receiver
XTP PI 400 Power Injector • Introduction
OUTPUTS RELAYS
OVER XTP
AUDIO
AUDIO
RS-232 IR L R 1 2
ON RESET
OFF
+ - + -
Tx Rx G Tx Rx HDMI S/PDIF
XTP PI 400
4
PWR
XTP XTP PWR
SIG LINK
POWER
RESET
12V
RS-232
1.0A MAX.
XTP OUT
Tx Rx
XTP T UWP 202
Transmitter
OUTPUTS RELAYS
AUDIO
L R 1 2
RESET
+ - + -
S/PDIF
1