Led Indicators - Extron electronics XTP PI 400 User Manual

NOTE: When using CAT 5e or CAT 6 cable in bundles or conduits:

LED Indicators

Figure 8.
A
B
C
Number of Patches
1 or 2
3
• Do not exceed 40% fill capacity in conduits.
• Do not comb the cable for the first 20 meters where cables are straightened,
aligned, and secured in tight bundles.
• Loosely place cables and limit the use of tie wraps or hook-and-loop fasteners.
• Separate twisted pair cables from AC power cables.
A B
XTP POWER OUT
1 2 3
Front Panel Features
Front panel power LED indicator — Lights to indicate the XTP PI 400 is receiving
power.
Front panel XTP Power Out LED indicators — Light when the XTP PI 400 is
providing power to XTP devices connected to the XTP PWR connectors.
NOTE: If the last connected XTP device that requires power draws more power
than the XTP PI 400 can provide, the corresponding XTP Power Out LED
indicator blinks, indicating the output cannot be powered due to the over power
draw. Disconnect the XTP device to correct the issue.
Rear panel Pwr LED indicators — Light or blink to indicate
the various power states of the XTP device connected to the
corresponding XTP PWR connector (see the table below for LED
states).
LED State
Unlit The endpoint is not connected or cannot
be powered.
Lit The endpoint is receiving power from the
XTP PI 400.
Blinks five times There is a power overload fault.
Blinks nine times The power allocation is exceeded.
Maximum Transmission Distance
330 feet (100 meters)
280 feet (85 meters)
4
Port Status
XTP PI 400 Power Injector • Installation and Operation
XTP PI 400
XTP POWER INJECTOR
C
PWR
XTP XTP PWR
XTP Port
8