Table of Contents
Advertisement
INTELLICENTER
(Replacing Existing Wireless Antenna with High
Power Wireless Link
WARNING Switch OFF the main power to the Load Center
before making any connections.
1.
Switch OFF the AC power to the enclosure at the main house panel circuit
breaker.
2.
Unlatch the front door latch and open the front door. Remove the two
retaining screws from the High-Voltage Cover Panel and remove the panel.
See Figure 5 on page 10.
3.
Loosen the two retaining screws securing from the top edge of the Outdoor
Control Panel. Fold down the Outdoor Control Panel to access the circuit
board sockets connectors for the electrical connections. Remove the panel
from the enclosure (see illustration below).
4.
Disconnect the Ethernet cable from the existing transceiver. and
remove the transceiver: To access the transceiver Ethernet port, remove
the rear bottom panel from the antenna assembly. From the front of the
antenna assembly, press down on the rear bottom panel clip to release it
from the antenna assembly. See Figure 7 on page 14.
5.
Remove the two screws securing the existing transceiver and remove the
transceiver from its mounting position.
6.
Connect the HPW Link Outdoor Transceiver: Connect the Ethernet cable
(from the IntelliCenter Control System Power Module) to the Ethernet port
on the HPW Link outdoor transceiver circuit board.
7.
Mount and secure the HPW Link outdoor transceiver in the same location
as the existing transceiver. Secure the transceiver in place with the two
screws.
8.
Slide case up over the circuit board and antenna into the back plate.
Secure the circuit board in the case using the two retaining screws.
9.
Home Wireless Router Location: Connect Ethernet Cable (cat5) to
Indoor HPW Link Transceiver and to Home Wireless Router (See
Figure 8 on page 15): Connect the Ethernet cable (provided) to a port on
the home wireless router. Connect the other end of the Ethernet cable to
the HPW Link indoor transceiver.
10. Indoor Power Module Connection: Connect the AC Power Adapter plug
into the Power Module DC-IN socket and the plug other end into a AC wall
outlet.
System Start-Up
Refer to the IntelliCenter Control System using the step-by-step Setup Wizard.
For more information refer to the IntelliCenter™ Control System User's Guide
(P/N 522990).
®
CONTROL SYSTEM
High Power Wireless Link Kit Installation Guide
13
Hide quick links:
Advertisement
Table of Contents
