Summary of Contents for Terex Genie Lift Guard S-40
Page 1
Operator's Manual Supplement Lift Guard™ Sensor for Booms ® from S4015-20505 ® ® From S6012-24492 ® First Edition First Printing Part No. 1294064GT...
Operator's Manual Supplement First Edition • First Printing Introduction Intr oducti on Lift Guard™ Sensor for Booms The Lift Guard Sensor system is designed to alert the operator and occupants before the platform makes contact with an object from behind or above. The operator will be warned by light and joystick vibration when in close proximity to the object and boom movement will be interrupted before contact.
First Edition • First Printing Operator's Manual Supplement Introduction Lift Guard™ Sensor for Booms Pre-operation Inspection Safety Be sure that the operator’s manual, safety Read, understand and obey all warnings and manual, responsibilities manual and any instructions provided with the Lift Guard Sensor. necessary supplements are complete, legible and in the storage container located in the Do not exceed the rated platform capacity.
Operator's Manual Supplement First Edition • First Printing Introduction Object Behind Test: Function Test Start the engine from the platform controls. The system provides a visible and physical Note: If the Lift Guard Sensor LED and platform indication of objects behind or above the platform, control box vibration are activated without pressing when they are within the detection range of the on the footswitch, the machine must be tagged and...
Page 5
First Edition • First Printing Operator's Manual Supplement Introduction Object Overhead Test: Extend the boom towards the object so that the sensors are between 6 ft/1.8 m and 1 ft/0.3 m Locate a large item above the platform, such of the object. as an I-beam, and position the platform greater than 6 ft/1.8 m below the object.
Page 6
Operator's Manual Supplement First Edition • First Printing Introduction Activate Lift Guard Sensor toggle switch on the platform control box next to the LED button. Result: The Lift Guard Sensor LED will flash yellow light.Some functions will operate at reduced speed. Release the foot switch.
Page 7
First Edition • First Printing Operator's Manual Supplement Operating Instructions Operati ng Instr ucti ons Operating Instructions Note: The system is designed to supplement other safety practices and systems such as a signal person, and is not intended to be used as the sole method of collision avoidance.