Cleaning; Checking The Drill; Storage - FERREX FAB 20-Ib User Manual

NOTICE!
Risk of damage!
Improper handling of the drill may result in damage to the drill.
− Do not use any aggressive cleaners, brushes with metal or nylon bristles,
or sharp or metallic cleaning utensils such as knives, hard scrapers and
the like. They could damage the surfaces.

Cleaning

1. Allow the drill to cool down completely.
2. Remove the battery (see chapter "Using the battery").
3. Wipe the housing of the drill with a clean, slightly damp cloth. Make sure that no
water penetrates the housing.
4. Clean the contacts of the battery holder
5. Then dry the drill thoroughly and let it dry completely.
You do not have to oil the drill.
6. Remove drill dust and any chips from the quick-action drill chuck
connection contacts of the drill and the battery clean.
The drill is now completely clean.

Checking the drill

Regularly check the condition of the drill.
Among other things, check to make sure:
− that the switches are not damaged,
− that the accessories are in proper condition,
− the vents are unobstructed and clean. If applicable, use a soft brush to clean them.
If you identify any damage, you must have it repaired by a specialist workshop
to prevent risks.

Storage

Short-term storage during work
You can use the belt clip
− For example, simply clamp the drill to your belt with the attached belt clip. Always
make sure that the drill is hung securely on the belt clip and cannot fall when
using the belt clip.
5 if you need to temporarily remove the drill while working:
6 and the drill with a dry, clean cloth.
Storage
1 . Keep the
19