Table of Contents
Advertisement
After use
14. Let the drill cool off completely once you have finished work.
15. Remove the drill bit or the bit (see chapter "Removing tools").
16. Remove the battery (see chapter "Using the battery").
Removing a blockage
Follow the steps below to remove a blockage:
1. If the drill engages a blockage, release the On/Off switch
out of the drill hole.
2. Check whether the blockage is caused by the drill by briefly pushing the On/Off
switch. Do not point the drill bit towards yourself or other persons and animals.
• If it is not possible to start the drill, follow the instructions in the chapter
"Troubleshooting".
• If the drill is working properly, follow the next steps in this chapter.
3. When screwing, set the torque adjustment ring
4. Push the On/Off switch all the way down and apply some pressure to the drill.
5. Take occasional breaks and take the drill bit out of the drill hole so that the drill bit
can cool off.
6. Repeat steps 4 to 5 until the blockage has been removed.
After use
1. Switch the drill off by releasing the On/Off switch
2. Set the right-handed/left-handed rotation selector
position to prevent it from unintentionally activating.
3. Remove the battery (see chapter "Using the battery").
4. Allow the drill to cool down completely.
5. If necessary, remove the fitted tool.
Cleaning and maintenance
NOTICE!
Risk of damage!
Water or other liquids that have penetrated the housing may cause a short
circuit.
− Never submerge the drill and the charger in water or other liquids.
− Make sure that no water or any other liquids get into the housing.
18
8
and pull the drill bit
2
to a higher torque.
8
.
4
to the intermediate
Hide quick links:
Advertisement
Table of Contents
