Assembly Instructions - 49417 - Klutch 49413 Owner's Manual

1. Plac ce the frame assembly (1
2. Align n the holes o of two handle
nut ( (17), spring W Washer (18)
(See e Fig.2 or the e parts diagra
3. Inse ert hex bolt (3 34) with flat w
put t the flat wash her (35) and a
and hex nut (38) ) in the other
othe er wheel on t he other side
Note e: After tight ening nut M1
was her (35), the en remove th
4. Sec ure the moto or & gear box
with flat washer (28), spring
Fig.6 6 and the pa arts diagram.
5. Atta ch the protec ctive net (27
abov ve the net, th hen the fram
M6 ( (26) on each h bolt. (See th
6. Sec ure the drum m (6) to the g
wren nch. (Fig.8)
7. Sec ure the mixe er blades (2)
outs side of the dr rum and push
next t to the drum m inside, then
was hers 8 (10) a and nuts M8
8. The cement mix er assembly
Fi ig.1
Fig g.4
Fig. .7
As sembly I Instructi
6) in a clean n work area w
es (21) with t the frame as
flat washer (19), then se
am.)
washer (35) t through the w
across the m middle of the
r side of the w wheel and tig
e of the fram me.
12 (38), if the ere is a large
e nut, includ e a second w
x assembly ( (31) to the fiv
washer (29) and hex nut
)
) to the fram e assembly
e then and fl lat washers 6
he parts diag gram.)
earbox shaft t with T bolt a
to the inner s side of drum
hed through the blade ho
n the mixer b lades. Secu
(11). (See th he parts diag
is complete . Retighten
Fig.2
Fig.5
Fig.8
Page 10 of
ons - 494 417
with a flat, le vel floor surf
sembly (16) and insert th
ecure handle e sleeve (22)
whole on the e frame (16)
hole in a wh eel (36). Pla
ghten the nu t. Repeat thi
e clearance b between the
washer, and retighten the
ve holes (Fig .5) in the fram
t M6 (30). Tig ghten them b
(16). The ne t with three b
6 (24), spring g washers 6
assembly (1) ) (See fig.7).
m (3): Start wi th bolts M8 x
oles into the drum, then a
ure the blade s with flat wa
gram.)
all the nuts a and bolts.
Fig.3
Fig
f 18
face. (See Fi ig.1.)
he hex bolt (2 20), hex
to the handl le (21).
(See fig.3 & 4), then
ace a flat was sher (37)
s procedure with the
wheel (36) a and flat
e nut.
me assembl y (16)
by wrench. (S See
bolt M6 x 16 (23)
(25) and hex x nuts
Tighten firm mly with a
x 20 (1) on th he
a leather was sher (8)
ashers 8 (9), spring
g.6