Putting The Scu Into Operation - Eaton Holec Clink II User Manual

CLINK II SCU MANAGER
Local power supply
The local power supply configuration is set via LCU-5. Select:
, see table 5.
Configuration
Table 5: Setpoint System Configuration
Name
System configuration
4.4

Putting the SCU into operation

Power the Clink II system.
The SCU can be in six different operational modes. See figure 2 for an overview of transitions, modes and
corresponding Module LED signals. See also Troubleshooting guide‚ page 58
commissioning
Identity Object
Reset Service
(from any state
except
Maj. Unrec. Fault)
Fault
Corrected
Deactivated
Major
Recoverable Recoverable
Faults
Major Recoverable Fault
Led: Flashing Red
SCU Manager - Unit - Properties - tab System
Parameter
Description
type
LPS Setpoint
Nonexisting
Led: Off
Power
Applied
Device Self Testing
Led: Flashing Red/Green
Test
Passed
Standby
Led: Flashing Green
Activated
Operational
Led: Solid Green
Major
Major
Unrecoverable
Faults Faults
Major Unrecoverable Fault
version 5.0
Power Loss
Test
Failed
Minor
Fault
Led: Solid Red
13