Advertisement
Welcome to your new EarthQuaker Devices
we said we would never do... an overdrive based on the legendary TS808! Gasp! The horror!
Another tubes creamer?? In 2014?? Really?? After loads of requests, we finally buckled. We
ran tests with every popular clone on the market as well as several vintage originals, compared,
contrasted and took loads of notes. It was exhausting but informative. In the end, we threw it
all away, used our ears and came up with what we feel is the most versatile relative of the 808
available today.
With 6 different clipping voices, 5 bandwidth settings and 2 gain channels, you will be hard-
pressed to not find a setting that will wipe every mid-boosting overdrive off your board. The
clipping voices determine how transparent and open or tight and crunchy the distortion is. They
will vary drastically depending on where the gain is set, what channel is active and how much
bandwidth is being used. The Bandwidth (7) sets the frequency response of the distortion and
goes from thin, light and clean through fat heavy and crunchy. It may very well be the single most
important control the Palisades has and what really sets it apart.
Gain A (2) is a lower gain channel with a wider range of grit that is great for strumming open
chords. Gain B (4) is a higher gain channel with a tighter range that is great for palm muting and/
or shredding solos. The Palisades also has a foot switchable volume Boost (10) with adjustable
level to take it over the top when you want to throw your foot up on the monitor and rip your sweet
leads... or maybe just push the front end of you amp a little harder. Not enough? How about a
Normal/Bright (8) switch to mix and match the overall tone to different amps and guitars. Still
not enough? OK then, how about a Buffer (9) on/off switch to tighten up the tone and make it
sparkle when set to ON or warm it up and make it sag when set to OFF.
The Palisades is a versatile dude that will give you years of loving companionship. Each
Palisades is hand made one at a time in the tiny tree house community of Akron, Ohio.
Palisades
Overdrive! The Palisades is something
®
™
<<< Controls >>>
1
6
8
10
1
Boost: Sets the level of the output boost.
2
Gain A: Sets the gain for the Channel A
(lower gain)
3
Volume: Sets the output level.
Gain B: Sets the gain for Channel B
4
(higher gain)
5
To n e: B r i g h t e r c l o c k w i s e, w a r m e r
counterclockwise.
Rotary Switches
6
Voice: This sets the nature of the
Palisades distortion by changing the
clipping diodes.
1- No diodes: The most open and least distorted.
2- LED clipping: Light clipping with a lot of volume.
3- Mosfet clipping: Light gain OD with great
harmonics.
4- Asymmetrical Silicon clipping: Tighter light
gain OD closest to stock 808.
5- Symmetrical silicon clipping: Tighter distorted
tone.
6- Schottky Diode clipping: Looser fuzzy tone.
2
3
4
5
1 1
12
7
Bandwidth: This sets the overall tone
and gain structure of the Palisades.
1 is the thinnest setting with the least
amount of gain and 5 is the fattest setting
with the heaviest gain. Everything else
is in between. This control has a major
effect on all the settings of the Palisades,
especially the Gain and Voice controls.
Toggle Switches
8
Normal/Bright: Normal is a warm full tone.
Bright is livelier tone with more chime.
9
Buffer: Turns the input buffer on or off.
ON is a tighter and brighter tone while
OFF is a warmer tone with more sag. The
buffer is part of the drive circuit & is only
available when the Palisades is activated.
Foot Switches
10
Boost: Activates the output level boost,
Features Flexi-Switching.
1 1
Gain B: Activates Gain Channel B,
Features Flexi-Switching.
12
Activate: True bypass switch
7
9
Advertisement
