Using The Ceramic Hob; Operating The Ceramic Hob - Panasonic KY-R645RLJPQ Operating And Installation Instructions

Using the Ceramic Hob

Before use
• Read this guide, taking special note of the 'Safety Precautions' section.
• Remove any protective fi lm that may still be on the Ceramic Hob.
Using the Touch Controls
• The controls respond to touch, so it is unnecessary to apply
any pressure.
• Use the ball of the fi nger, not its tip.
• A beep will sound each time a touch is registered.
• Make sure the controls are always clean, dry, and that there is
no object (e.g. a utensil or a cloth) covering them. Even a thin
fi lm of water cause make the controls diffi cult to operate.
Start cooking
After connecting the Ceramic Hob to the power supply, a beep will sound.
1. Touch , all displays show
entered the state of standby mode.
2. Place suitable cookware on the cooking zone to be used.
• Make sure the bottom of the cookware and the surface of the cooking zone are
clean and dry.
3. Select the power level by touching the
zone. (Power level should be within 1-9)
• If the power level is not selected within 1 minute, the Ceramic Hob will automatically
switch off. The operation needs to start again from step 1.
• The power level can be changed at any time during cooking.
8

Operating the Ceramic Hob

or , indicating that the Ceramic Hob has
or control on the selected cooking