Table of Contents
Advertisement
5.2 Basic parameters
MODE (Switching between parameter groups)
Command
MODE
This command switches between several views on the parameter table. In order to improve the clearness
only the parameters belonging to the chosen group are displayed. There is also an option available to show
all active parameters at once.
5.3 System parameters
LG (Changing the language for the help texts)
Command
LG
Either German or English can be selected for the help texts.
SENS (Malfunction monitoring)
Command
SENS
This command is used to activate/deactivate the monitoring functions of the module.
ON:
All monitoring functions are active. Detected failures can be reset by deactivating the ENABLE input.
OFF:
No monitoring function is active.
AUTO: Auto reset mode. All monitoring functions are active. If the failure does not exist anymore, the
module automatically resumes to work.
Normally the monitoring functions are always active because otherwise no errors are detectable via
the READY output. Deactivating is possible mainly for troubleshooting.
PASSFB (Password fieldbus)
Command
PASSFB
The value inputted here serves as password for the parameterizing via fieldbus. For enabling parametrization
it has to be send via fieldbus to the relating address. For a value of "0" the password protection is deac-
tivated.
Page 21 of 65
Parameters
x
x= SYSTEM|IO_CONF|POS_1|
POS_2|SYNC|EXTRA|ALL
Parameters
x
x= DE|EN
Parameters
x
x= ON|OFF|AUTO
Parameters
x
x= 0... 10000000
POS-124-U-Ethernet
Unit
Group
-
BASIC
Unit
Group
-
SYSTEM
Unit
Group
-
SYSTEM
Unit
Group
-
SYSTEM
08.11.2018
Advertisement
Table of Contents
