Installing The Speakers On The Wall - Sony DAV-DZ700FW Operating Instructions Manual

Examples of poor conditions of the speaker cord
After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to
check that all the speakers are connected correctly. For details on outputting a test tone, see page 89.
If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker
other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this
happens, check the speaker connection again.
Note
• Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords
are reversed, the sound will lack bass and may be distorted.

Installing the speakers on the wall

1
Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.
See the illustrations below.
25 mm (1 inch)
2
Fasten the screws to the wall.
The screws should protrude 7 to 8 mm (9/32 to 11/32 inch).
3
Peel the seals off the two screw points on the rear of the speaker.
22
GB
Stripped speaker cord is
touching another speaker
terminal.
5
4 mm ( /
32
7 to 8 mm
9 11
( / to / inch)
32 32
Stripped cords are touching each
other due to excessive removal of
insulation.
4.6 mm
inch)
3
( /
16
10 mm
13
( /
165 mm (6
Hole on the back of
the speaker
inch)
inch)
32
1
/ inch)
2