Troubleshooting - Sony MDR-RF5000K Operating Instructions Manual

1 Additional Information

Troubleshooting

If you run into any problems using this headphone system, use the following
checklist. Should any problem persist, consult your nearest Sony dealer.
Symptom Cause and remedy
No sound
, Check the connection between the transmitter or and the AV component.
, Check that the signal is not being input to the digital out jack by mistake when
, Check that the connected AV component's optical digital output is set to "ON"
, Make sure that optical digital output of a connected AV component is set to
, Turn on the AV component connected to the transmitter, and start the
, Check that the INPUT SELECT switch on the transmitter is set to the
, If you connect the transmitter to an AV component using the headphone jack,
, Make sure you are wearing the headphones correctly.
, Raise the headphone volume.
, The headphones' POWER indicator goes off.
, You are playing back a DVD disc recorded in DTS when the DVD device
, The transmitter's ID is not set for the additional headphones.
, Additional headphones are being charged.
digital input is selected.
when selecting digital input.
PCM. (Excessive noise may occur if signals other than PCM are input to this
unit.)
playback.
component you want to listen to.
raise the volume level on the connected AV component.
• Charge the rechargeable battery if it is weak, or replace alkaline batteries
with new ones. If the POWER indicator is still off after charging the battery,
take the headphones to a Sony dealer.
(including game machines) and the transmitter are analog-connected.
• Use the digital connection. (Analog sound may not be output from the DVD
device.)
• Remove additional headphones from the transmitter.
Additional Information
(Continued)
US
23