Table of Contents
Related Manuals for Radiwarm 3100
Summary of Contents for Radiwarm 3100
- Page 1 Install real water- filled radiators where plumbing or gas supplies can’t reach INSTALLATION & OPERATING INSTRUCTIONS Installer please note: Revision Date Leave installation and operating instructions with customer 0501M077.L 19/06/2019...
-
Page 2: Table Of Contents
Your RFC Unit. Setting the Time and Day Factory set Program Frost Protection 4°C Celsius or Fahrenheit Adaptive Start (Auto Advance) Setting the 7 day program Trouble Shooting Guide After Sales Service Document RADiWARM - Operator Revision Page 2 0501M077.L Date 19/06/2019... -
Page 3: Important Safety Information
This radiator must be used on an AC supply only, and the voltage marked on the radiator must correspond with the supply voltage. Installation must be in accordance with the requirements of the current edition of the IEE Wiring Regulations 17th Edition. Document RADiWARM - Operator Revision Page 3 0501M077.L Date... - Page 4 Warning The radiator must not come in direct contact with water. This includes excessive humidity or using wet hands to operate the controls. Document RADiWARM - Operator Revision Page 4 0501M077.L Date 19/06/2019...
-
Page 5: Installation Instructions
For optimum output, the bottom of the radiator should be 150mm from the floor. Any shelf or substantial projection should be a recommended minimum of 150mm above the top of the radiator. Document RADiWARM - Operator Revision Page 5 0501M077.L... -
Page 6: Fitting
If the bottom of the radiator is below the top of the skirting board, it may be necessary to remove a section of skirting for this purpose. Document RADiWARM - Operator Revision Page 6 0501M077.L... - Page 7 (B) to its original position, thereby securing the bottom of the radiator in its final position. A) Plastic Grommet A) Plastic Grommet B) Catch securing radiator B) Catch in lowered B) Catch in raised position position Document RADiWARM - Operator Revision Page 7 0501M077.L Date 19/06/2019...
-
Page 8: Operating Instructions
Note It is strongly recommended that radiators (all models) are run for ½ hour each month during the summer to ensure that the pump is fit for winter operation. Document RADiWARM - Operator Revision Page 8 0501M077.L Date 19/06/2019... -
Page 9: Radio Frequency Control (Rfc)
If you don’t replace them for two weeks the symbol will start to flash. You must reset the clock after changing the batteries, but all other settings are unaffected. Document RADiWARM - Operator Revision Page 9 0501M077.L... -
Page 10: Connecting Your Radiator To Your Controller
For radio control to work, you first need to establish a radio connection between your radiator and your RFC. You may wish to follow this procedure if you add more radiators. Turn the radiator thermostat knob fully clockwise. Switch the Document RADiWARM - Operator Revision Page 10 0501M077.L Date 19/06/2019... -
Page 11: Choosing A Position In The Room
Clean the RFC Clean the RFC only with a soft, lint-free cloth. Avoid getting moisture on buttons or openings. Do not use sprays, liquids or abrasives; doing so may damage the RFC. Document RADiWARM - Operator Revision Page 11 0501M077.L Date... -
Page 12: Reverting Your Radiator To Manual Control
After selecting a new ID you must re-connect your radiator(s). Frost Protection If used with the RFC, the controller can be used to set the radiator to the frost protection mode. Ensure the control knob is not turned off. Document RADiWARM - Operator Revision Page 12 0501M077.L Date... -
Page 13: Cleaning
Do not use detergents, abrasive cleaners, or polish on the radiator as these may damage the finish. Wipe the radiator with a dry cloth to remove dust and marks. Note Only external cleaning is permitted. Document RADiWARM - Operator Revision Page 13 0501M077.L Date 19/06/2019... -
Page 14: Your Rfc Unit
6.0 Your RFC Unit. Document RADiWARM - Operator Revision Page 14 0501M077.L Date 19/06/2019... -
Page 15: Setting The Time And Day
- - -.The snowflake symbol appears if the actual temperature ever falls below 4°C. Celsius or Fahrenheit Pressing BOOST SET-BACK together changes Actual and Target temperature between Celsius Fahrenheit. Document RADiWARM - Operator Revision Page 15 0501M077.L Date 19/06/2019... -
Page 16: Adaptive Start (Auto Advance)
RFC1 with up to 6 temperature levels per day. Program times cannot overlap, for example if PROG.3 Mon is 16:30 then PROG.3 Mon can only be set to times before 16:30. Document RADiWARM - Operator Revision Page 16 0501M077.L... - Page 17 CLEAR returns to stage 1 Manual Operation If you clear all 6 programs in all 7 days, there is no program at all. The temperature control is done entirely by Quick Adjust. Document RADiWARM - Operator Revision Page 17 0501M077.L Date...
-
Page 18: Trouble Shooting Guide
Supply light is Green and stays on Tuned to factory controller Follow instructions 5.2 Supply light Is alternating red-green One of the fail-safe safety devices Follow instructions 3.0 flashing. has operated. Document RADiWARM - Operator Revision Page 18 0501M077.L Date 19/06/2019... -
Page 19: After Sales Service
After Sales Service Radiators manufactured by RADiWARM are covered by a two year warranty from date of purchase. We will repair or exchange within this period any part found to be defective due to a manufacturing fault. Should you experience any problems with your radiator do not try to rectify it yourself as this will invalidate the warranty.
Need help?
Do you have a question about the 3100 and is the answer not in the manual?
Questions and answers