Related Manuals for DIGISYNTHETIC Pro series
Summary of Contents for DIGISYNTHETIC Pro series
- Page 1 SERIES DSM 104 DSM 134 DSM 164 DSM 204 DSM 1043 POWER DSM 1345 POWER OPERATING INSTRUCTION...
- Page 2 1 PREACUTIONS -Read this manual carefully follow the instructions before using the mixer.Keep the manual for future reference and for out new ways of using the system.Keep the packing too:as well as ensuring that the equipment remains in good condition,it is also an important factor when the unit is valued for sale on the second-hand market.
-
Page 3: Front Panel
3 FRONT PANEL MONO CHANNEL SECTION EFFECT MASTER SECTION STEREO CH ANNEL SECTION SECTION REAR PANEL DSM 1043 DSM 104 DSM134 DSM 1345 DSM 164 DSM204... - Page 4 tones); tum the knob clockwise to boost mid 4 MONO CHANNELS SECTION frepyencies (sound body is highlighted, greater overall sound power and more nasal 1 MIC tone). Neutrik electronically XLR connector : controls the low range of signals ( input socket. For connecting low level 15dB).
-
Page 5: Left.right
turn the knob clockwise to Boost low 5 STEREO CHANNEL SECTION sounds are removed); turn the knob clockwise to boost low freuencies (more 15 LEFT RIGHT PIN JACK fullbodied sound, highlighting of main This use for conectionctionction into signal frequencies, percussive sound line level equipment. -
Page 6: Effect Section
6 EFFECT SECTION 28 REC OUT This jack can be connected with cassette deck when recording the mixed out. 29) AUX1.SUX2 SEND Unbalance jack connectors for connection of monitors, either amplified or for amplification; the output signal level is regulated by the Aux1.aux2 controls. -
Page 7: Master Section
7 MASTER SECTION 41) MAIN OUT XLR connectors which supply the signals controlled by the MAIN LIR Fader (56), the signal taken from these outputs requires use of a remote amplifier for connection to the speakers if active spea kers (with bullt -in amplification) are used,direct connection without a remote amplifier is possible . - Page 8 8.MULTEFFECT 47 MULTI-EFFECTS PROCESSOR 01 CATHEDRAL 1 12 STAGE 23 MED FLANGER 02 CATHEDRAL 2 13 VOCAL 24 BRIGHT FLANGER 03 MEDLUM PLATE 14 PERCUSSION 25 DELAY&REVERB 04 BRIGT PLATE 15 SHORT DELAY 26 CHORUS&MREV 05 SMALL HALL 16 MEDIUM DELAY 27CHORUS&LREV 06 MEDLUM HALL 17 ECHO...
-
Page 9: Fuse Holders
9 SUPPLY AND POWER SECTION 50 51 52 50 AC POWER CARD AC200V-240V 50-60Hz 51 FUSE HOLDERS When occur a problem on this appliance,the fuse will be cut off power to prevent fron problem. Fuse: TIA (DSM-104 DSM-134 DSM-164 DSM-204) T4-6A(DSM-1043 DSM-1345) 52) POWER SWITCH Push this switch ON , when you want to operate, the power LED (32) will be light up.
Need help?
Do you have a question about the Pro series and is the answer not in the manual?
Questions and answers