Page 1
This will determine its location on the convection air jacket of the insert. If the projection is greater than 0”, a projection kit AC01323 will need to be used before the installation of the cast iron faceplate. See step 3.
Page 2
Step 1: Support brackets installation 1.1. Position the insert in its final location in order to measure the projection of the cast iron faceplate from the front of the fireplace finish. 1.2. Secure the mounting brackets (C) (see DETAIL 1) on each side and (A) (see DETAIL 2) on the top of the convection air jacket (D) with screws (B).
Page 3
Align the holes in the panel (F) with the inner holes of the brackets (C) and secure with two screws (B). Note: If your installation requires the addition of a projection kit AC01323, go to step 3. Otherwise, go to step 4.
Page 4
3.2. Projection kit assembly (4" projection shown) Secure the side projection (G) to the top projection (H) by the means of two bolts (K) and two nuts (L). Repeat this procedure for the assembly on the other side (J). 3.3. Projection kit installation Align the holes inside the projection kit assembly with the corresponding holes on the faceplate backing plate and fasten with 6...