Charging The Appliance; Mains Operation - BaByliss for MEN Super Clipper XTP Manual

INSTRUCTIONS FOR USE

Charging the Appliance

IMPORTANT!
This clipper is so easy to use, but before you do anything you must
take your time to charge the unit for 2 hours before its first use. Even
if you want to use it plugged in straight from the mains, this initial
supercharge ensures optimum power performance to give smooth
fast cutting every time. Maximum battery capacity will only be reached
after 3 charging/discharging cycles. A 2 hour charge will provide
approximately 85 minutes use. A 30 minute quick charge will provide
approximately 30 minutes use.
When charging the appliance the blue LED charging light will flash
slowly and continuously until the battery has fully charged, then the
blue LED charging light will stop flashing but remain on.
NOTE: Do not charge the appliance for longer than the recommended
time
Warning: If the charging light suddenly starts to flash rapidly then
the appliance is faulty. If this happens then please stop charging and
remove the adaptor from the mains and contact our Customer Care
Centre for further advise (see the 'After Sales Service' section of the
information booklet).

Mains Operation

• Ensure the appliance is switched off.
• Connect the adaptor to the base of the appliance and plug the
adaptor into a suitable mains socket.
• The blue LED charging light will flash when the adaptor is correctly
inserted into the appliance and connected to the mains.
• The appliance is now ready for use.
• NOTE: The appliance should not be used for longer than 20 minutes
when operated from the mains.
Only use the adaptor supplied with this appliance.