Charging The Clipper - BaByliss for MEN EASYCUT E940XE Manual

ENGLISH
EASY CUT
CUTS AND MAINTAINS VERY
SHORT HAIR
The BaByliss Easy Cut is a
completely
revolutionary in its design, and
ideal for cutting and maintaining
very short hair cuts.
Because of its circular blades,
the clipper can be used in any
direction over the head while
guaranteeing a perfectly even
cut.
The unique comb guide can be
adjusted to 3 different lengths: 3,
6 and 9.5mm.
Putting the finishing touches to
the sideburns, around the ears
and at the neckline can be done
with the trimmer for finishing
provided in this pack.
IMPORTANT: Please read the user
manual for the Easy Cut clipper
carefully before using the unit for
the first time.
This unit is intended only for cutting
hair short and should under no
circumstances be used on the face
or any other part of the body. In
particular, do not use the Easy
Cut clipper near your ears (use the
separate finishing trimmer intended
for this purpose). Never let your ears
get into the clipper blade ring!
new clipper,
FEATURES
1. Multi-directional circular blades.
Stainless steel mobile (91 teeth)
and fixed (79 teeth) blades
2. 1 comb guide with 3 settings (3-
6-9.5 mm)
3. Comb guide
mechanism
4. On/Off switch
5. Red charging indicator light
6. Green
indicator
7. Adaptor for use on the mains
and for charging (not showed)
8. Finishing
operated)
9. 1 5-position (3-6-9.5-13-16mm)
comb guide for finishing
10. Oil, cleaning brush, storage
pouch (not showed)
IMPORTANT
REGARDING
BATTERIES OF THIS UNIT
To achieve
maximum
charge the batteries for 16
hours before using for the first
time and then approximately
every 3 months. The unit's full
capacity will only be reached
after three
discharging cycles.

CHARGING THE CLIPPER

1. Insert the power cord into
the unit and into the adapter.
Before using the clipper for the
first time, allow it to charge for
16 hours. Make sure the switch
on the clipper is in the OFF
position.
8
with locking
in-operation
clipper (battery
INFORMATION
THE
and maintain
battery capacity,
charging
LED
NI-MH
and