Table of Contents
Advertisement
The appliance is also supplied with 2 taper guides
The taper guides can be used above the ear to get a clean line.
• Attach either the left or right guide depending on which ear you are
cutting above.
• Angle the clipper and gently stroke around the ear towards the back
of the neck.
Taper Control
The taper control lever enables fine cut adjustment for precision
clipping.
• To increase the cutting length, push the lever down.
• To reduce the cutting length, push the lever up.
Preparation for Use
• Always inspect the appliance before use to ensure the clipper blades
are free from hair, debris etc.
• For best performance, use on clean, dry hair that has been combed
until tangle-free.
• Ensure the appliance is sufficiently charged or plugged into the mains.
NOTE: The appliance should not be used for longer than 20 minutes
when operated from the mains.
Clipping
For an all over even cut:
• Attach a comb guide as required – your clipper is supplied with 8
comb guides (grades 1-8). Each comb guide is labelled.
• Switch the clipper on and the blades will start to move.
• Starting at the nape of the neck, hold the clipper with the teeth of the
clipper pointing upwards, ensuring that the comb guide is resting flat
against the head.
• Slowly move the clipper upwards and outwards through the hair
towards your crown, against the direction of the hair growth. The
comb guide will help to lift the hair and the blades will cut the hair at
the desired length.
• Once the desired length is achieved at the back of the hair, start
clipping the top and sides.
• Hold the clipper to the front of your hair with the teeth pointing
towards the back of your head, and move the clipper towards your
crown. Repeat as necessary, moving in rows from the front and the
Hide quick links:
Advertisement
Table of Contents
